If you are able to access the controller, you can check the system’s communication settings to make sure that it is appropriately linked to the control unit. If these are fine, the issue may be with the control unit itself. If the breakers are good, check the power source to the controller and check that the cable connections are secure. Check the breakers in your electrical panel to see if any have been tripped. If the power source has been affected, it could be that a breaker has been tripped. It could be that there is an issue with the system’s sensors, or the system has extinguished an alarm condition. It could indicate that there is an issue with the power source, or the system is not communicating properly with the parent control unit. If your Pentair system says “offline,” this could indicate a number of issues. Make sure that the components are functioning as expected before end-users start using the system. Test that all the components are working properly: Once the components are connected to the main control unit, test them by using the buttons or controls available. Check the instructions for your brand or model for the steps required to successfully connect the components to the main control unit.Ĥ. Link the components to the main control unit: Depending on the brand and model of your system, you may need to link the components to the main control unit using a computer or a tablet. Make sure all the components are securely plugged in and that the power cord is long enough to reach all of the components.ģ. Connect the components to power: Plug the power cords that come with the wireless components into an approved outlet.
In most cases, theeasiest way to re-establish a connection is to perform a cold boot of the ScreenLogic2 device: a.2. Make sure your wireless ScreenLogic2 device is connected to your wireless router.
If ScreenLogic2has been previously working without a problem, try the following steps to resolve the problem: 1. What to do if your screenlogic2 is not working? I have had two adapters go bad with similar symptoms as yours. If shown as inactive, and you have rebooted everything then your Protocol adapter has died. Go into your router settings program and see if the Pentair protocol adapter is showing as active or inactive. What to do if your Pentair adapter goes bad? If that works you know your protocol adapter is good and the wireless link is bad. Remove the wireless link from the picture. Get a 4 conductor cable 18-22 awg and use it. What should I do if my Pentair screenlogic is not working?ĭirect connect your protocol adapter to the ET panel and your network router or switch via hardwire.
0 kommentar(er)
